Personally I like the non-drilling ones and put them through a small pilot hole so I can make sure they don't go in crooked. You'll have an easier time going in with the self-drilling kind (they look like they have a little drill bit on the end), though some people go through without them just fine. They often take 3/8" to 1/2" holes to insert, which is barely lower than the width of a lot of steel studs.įor most applications, use the same thing that is holding those heavy gypsum boards up in the first place: fine-threaded drywall screws. Especially if you're going into the kind of small, lightweight ~25 gauge steel studs you'll find in most condo apartments, you'll find that putting one of those toggles through a steel stud to be as good or even weaker than simply going through the drywall. The hole you need to drill is wide, so you're scraping out a lot of the stud just to make it. ![]() I've had very poor experiences anchoring into steel studs using toggles.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |